Dick Piers blog. IAM genital play piercing since 1996 and bought first edition of BME Modern Primitives. 

MODS: 0 gauge 5/16-in 8.3 mm apadravya behind the corona / halfadravya / reverse PA

RETIRED: 6 ga Prince Albert to subincision, 12 gauge apadravya to head split, 12 gauge ampallang

INK: none


Dead head (but I like it)
4/30/2017 | 2 comments

Numb as my thumb, can have sex indefinitely

Webcam modeling
4/17/2017 | 5 comments


It's too small ! Lol
4/3/2017 | 0 comments

I have to go larger to 00 gauge. Enough is never enough. I'll begin wrapping the pin with electrical tape. It's like anorexia only I have to make my shaft piercing ever larger.

Really fucking depressed
4/2/2017 | 4 comments

I kind of like it

Finally I did it. Zero gauge shaft.
3/26/2017 | 0 comments

It took me 2 months to taper my halfadravya from 2 to 0 gauge. The calor taper was helpful. But it was too short for such a thick area to stretch. I had placed a potato between my cock and a C-clamp to push thru the taper. I almost ran myself thru the first try. The pain was just too much. It fell out sleeping and swelled close.

That got the tearing started. I tried and tried just to push the taper thru to no avail. Eventually I went back to my first method: Tape layering. Layering electrical tape over a stainless 1/4" clevis pin proved to be successful. I pulled the pin last night with ten layers tape, inserted the taper, and pushed by jewelry thru.

It's a 3/4" zero gauge barbell in black.


2941 headshots.

Back to Top