Using tape to layer over a 4g shaft, I got back into the barbell shown at the right. It wasn't painful as nothing tore so infection couldn't occur. Now the 4g barbell I ordered is obsolete. But I still intend to use it to layer tape. When I can pull the bead thru, I'll measure that circumference, use a clevis pin retainer, and buy the next size up.

The weight of the padlock after four days was just shredding my cock piercing. There was a dull ache that became unbearable. Once the skin heals back stronger, I'll wear the lock again. I'm sorry I still can't upload the video. There was too much internet traffic during Thanksgiving weekend. I'll try Monday. I plan to layer tape again to get gently back into my 2 gauge barbell.

The weight of the padlock after four days was just shredding my cock piercing. There was a dull ache that became unbearable. Once the skin heals back stronger, I'll wear the lock again. I'm sorry I still can't upload the video. There was too much internet traffic during Thanksgiving weekend. I'll try Monday. I plan to layer tape again to get gently back into my 2 gauge barbell.

I have no jock support while asleep so it's hard to adjust to wearing a padlock 24/7. I made a video at church on Thanksgiving in the bathroom. I'll upload it soon. I'm going to make more video from now on. I think you'll like seeing me pull and rotate my cock with a padlock thru it.

As I layered tape over a 6 gauge barbell, to taper my penis shaft piercing, it did not rip as with a mechanical taper. That allowed me to insert the 3/16" diameter padlock without pain. I've been lubricating it with baby oil. The straight hole is almost fully acclimated to the curvature and weight dangling all day. When it gets tender, I replace my cock in my shorts for support. The 4g barbell arrives on the 8th of December. That's plenty of time to keep myself locked and stretched. I plan to layer tape over the 4 gauge to step up to the curved 2 gauge barbell again without tearing or getting infected. Then I can step up to a heavier, larger padlock with a 1/4" diameter shank.