Homemade PA

At A Glance Author bdarob Contact bdarob@bme.anon Artist self inflicted Studio at home Location Bermuda

I have always had an interest in body modifications throughout my teen years. This started when I was twelve and I tried many things like sticking air tubes from a fish tank pump down my urethra and pins through my foreskin. I had heard of people having genital piercings but was not aware of the types that could be performed.

While at University I would continue my forskin piercing but never put any thing in and this always healed back up. It was not until I was 37 that I actually put a siver ear ring into my foreskin. I had this in for about a year and I was quite happy with it.

It was not until I saw pictures from BME and saw a picture of a PA on the Internet and thought that I would like to have one, that my true piercing feelings came out. I thought that the PA looked so good and I thought about it often. I started to think of how I would get such a thing done in Bermuda. Without wanting to bring undue attention to myself I knew I would have to do the PA Myself or wait until I went to the USA. As this was something I really wanted and I did not know when I would next be of Island, I did the work myself.

One afternoon I got a sewing needle and prepared it for the task at hand. I used alcohol on the needle which also had a thread attatched to keep the hole open as I did not have any jewelry and I did not have the nerve to put a 12ga. hole into myself. I opened my urethra with a Q-tip along with the needle until it was in the right location. I then just pushed the needle through and pulled the thread through and tied it off.

After a couple of days I used a regular earring to keep the hole open. As this was not an ideal situation I started to look for a means to enlarge the hole to the recommended 12ga. I used a steel "O" ring which I cut and sharpened the end into a point. I got the point started in the hole and then slowly over a few weeks worked the metal ring around until the 12ga. was achived. The metal ring was a bit of a problem because it would catch in my underwear and this would hurt some.

I used alcohol on a regular basis to ensure that I did not get infected. As my tools were a little out of the ordinary I had to be very careful with sterilizing what I used. I would boil the items in water prior to use and then use alcohol.

Over the next few weeks I worked on enlarging the hole with a tapered stainless steel probe. until I could fit a 10ga ring in. I carried out several sessions using petroleum jelly to help the probe enter the hole.

It was such a rush to be pushing the probe through what started as a small hole which was now getting larger as each session ended.

I used a small pad lock one time to keep the hole open. More often I used a rubber "O" ring to keep the hole open. The rubber would give a little in my pants and this made life more enjoyable while out working. I found the metal ring that I made caught in my underware and would pull and hurt.

I had to fabricate this with a ring bought from a hardware store but it worked until I could go away and buy what I wanted. I found that the hardware gauge is larger than the jewelry gauge thus I now have a 8ga PA instead of a 10ga.

I have seen pictures of 0ga. jewelry and this is a great turn on for me. I would like to get a smaller gauge, but don't know yet if it will be a 6ga. or 4ga.

I have also made a PA wand out of a stainless steel bolt and have used this on several occations I have a large one inch ball on the end and a 3/4 inch ball for the holding pin. The weight of this on my cock is such a turn on. I have heard of sounds for enlarging the urethra and want to look into doing this sometime in the future as well.

I have enjoyed doing my own PA and this did not hurt as many would think. I plan to do my own nipples and my ears but would use a profesional for my tongue if I do it.

I plan to get my tongue pierced next and also my nipples.

Will send in info on the new piercings when they have been done.